DSC05209 Share this:RedditTwitterFacebookTelegramLinkedInWhatsAppSkype By Martin | March 11, 2012 | 4 Comments | ← Previous Next → 4 thoughts on “DSC05209” Dan March 15, 2015 at 4:57 pm Hello, Please tell how did you managed to fool the inside air temp sensor to much higher temps of the plate heat exchanger. Thanks Reply ↓ Martin Post authorMarch 15, 2015 at 5:20 pm Used a potentiometer in series to the thermistor to find suitable value Reply ↓ Max September 23, 2020 at 6:15 pm Hi,olease, how do i callcullate out the volume of plate heat exchanger to suit with my compressor unit. Thnx in advance for answer. Reply ↓ Doug Lockhart December 14, 2020 at 10:22 pm Hello Martin, I have a couple problematic units that won’t defrost but I believe the ‘oil return mode’ Bottom line is IMHO, that their ‘oil recovery mode’ is causing a partial unintended defrost of the outdoor coil with then leaves a refreeze of the slush to hard clear ice……..a heat pump can’t deal with this so they start to ice up and then it gets worse and worse from more partial defrosts. What is your sense? I have been self employed for 45 years and have built some of my own proprietary very wild systems. Love to talk. Reply ↓ Leave a Reply Cancel replyYour email address will not be published. Required fields are marked *Comment * Name * Email * Website Notify me of new posts by email. Δ This site uses Akismet to reduce spam. Learn how your comment data is processed.