I first tried to read our Paradox alarm in 2013 by tapping the keypad bus, then in 2014 through the panel’s serial port, and later with an ESP bridge. All three could read the state, none could arm or disarm. Back in 2013 I even wrote: “Of course Paradox offers product to do exactly this, but where is the joy of hacking things?”
In 2023 I wanted to arm and disarm it from Home Assistant as well. So I bought Paradox’s own IP150 module and paired it with PAI, the Paradox Alarm Interface, which is much better maintained than what I had.
Buying the IP150 was out of laziness, and to be honest without enough due diligence of the pitfalls. The first one: the stock firmware happily floats my house’s state to Paradox’s cloud. The module has a CISA advisory for remote code execution. A 2021 write-up lists a hardcoded password and unsigned firmware updates.
A PAI user posted the way out: firmware 5.06.016, picked during the upgrade with the access code IP150PCN, keeps the module on the local network only. The module’s own web page stops working.
The second pitfall: a newer BabyWare made me change the panel’s PC password, and PAI could not log in after that. It took a factory reset of the panel and a restore from backup.
Overall, it works and I use it heavily in automations. I won’t list them all, there is a security veil I need to keep. The harmless ones: the alarm’s motion sensors switch the hallway and porch lights, an open window pauses that room’s heating (planned in my 2014 post), and the robot vacuum only runs after the first floor has gone quiet. Like the vacuum, the alarm got more useful once it was in Home Assistant.
If I’d do it again, I’d properly design a dedicated PCB around PAI support.
